Peugeot 403 truck 28.5mm rear cylinder required

" Front wheel cylinder repair kit, with pistons and spring. (For one wheel) Piston diameter = 28.57 mm "

€24.30 TTC
(20,25 € HT)

Contactor: copper seal kit for LONG stop contactor 022114

Set of 2 seals for STOP LONG contactor

€3.60 TTC
(3,00 € HT)

7/16 banjo fitting + 7/16 hollow screw + seals

7/16 banjo fitting + 7/16 hollow screw + sealsDiameter male thread of the screw 11 mm

copy of Brake pipe - from 250 to 300 cm

Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.

Copper gasket 13.5x20.5

Copper gasket 13.50 x 20.50 th 1mm

€1.85 TTC
(1,54 € HT)

Copper pipe fitting 7/16 - ext thread 11mm

Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm

Copper gasket 10 x 18

Copper gasket 18x10 mm thickness 1mm

€2.16 TTC
(1,80 € HT)

Rear brake cylinder 25.4mm - cone protruding - Peugeot 403

Rear wheel cylinder d 25.4mm, inclined pipe inlet 7/16. Exiting cone visible at the bottom of the liquid inlet on the cylinder.Non contractual photo.

€60.60 TTC
(50,50 € HT)

Dot 4 brake fluid

Dot 4 brake fluid - 500ml can. Non contractual photo

Copper gasket 12 x 18 mm

Copper gasket 12 x18 x  1.5mm thick

€1.80 TTC
(1,50 € HT)

Excentrique de frein - Peugeot 203 403 404

Male thread brake reservoir

Brake fluid reservoir. Supplied with bracket, plug and 3/4 male connector 16 threads / p. External thread diameter = 18.5 mm. Delivered without caliper (fixing by the thread on the master cylinder). Lockeed and silicone compatible

Brake reservoir with nipple + contact

Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level

copy of Brake line - from 51 to 99 cm

Brake line remanufactured on request, only in copper diameter 6.35 mm. Large model, length from 50 cm, max 2m. Provide model (length and 2 original tips)Shipping after receiving your model.

Special brake grease tube - Plastilub ATE - 75 ml

Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!

Pipe Ø 8 mm from reservoir to master cylinder - 1 m

Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...