
Brake line - from 150 to 200 cm
Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.
(57,70 € HT)
Brake pipe - from 250 to 300 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(69,70 € HT)
Adapter connection 7/16 UNF female - 1/2 UNF male
Adapter connection 1/2 UNF male - 7/16 UNF female
(10,05 € HT)
Brake reservoir - male thread + electrical contact
Brake fluid reservoir, translucent plastic. With cap, and electrical contact for low fluid level
(39,50 € HT)
Brake line - from 200 to 250 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(63,70 € HT)
Brake clip spring kit - front wheels - Peugeot 403
Brake spring kit for front wheel - Peugeot 403
(22,00 € HT)
Brake hose 412 mm front Peugeot 403
Front brake hose for Peugeot 403 all models - Length 412 mm
(27,00 € HT)
Rear brake cylinder 25.4mm - Incoming cone - Peugeot 403
Rear brake cylinder - with entering cone - D 1 "(25.4 mm).Sold individually (1 cylinder per wheel)
(43,25 € HT)

Brake pipe - from 300 to 350 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(75,70 € HT)
Rear brake cylinder 25.4mm - cone protruding - Peugeot 403
Rear wheel cylinder d 25.4mm, inclined pipe inlet 7/16. Exiting cone visible at the bottom of the liquid inlet on the cylinder.Non contractual photo.
(50,50 € HT)

Pipe connector 1/2 20 UNF - tube 6.35 mm - external thread 12.5 mm
Rigid brake line nut. 1 / 2-20 UNF or Ø 12.5 mm - drilling for 6.35 mm tube (1/4 p)
(4,50 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)