Oil filter foot gasket Ford Vedette Simca
Gasket to be placed between the central crankcase and the base of the oil filter. "Y" shaped.
(16,40 € HT)
Carburetor gasket Stromberg Ford Vedette
Gasket for 22.2 Stromberg carburettor
(16,50 € HT)
bearing stops - Ford 1949 to 52
Set of 4 retainers for V8 Ford Vedette 1949 - 52 (Strainer with spring and support on central bearing)
(20,70 € HT)
6V electric fuel pump
6V electric fuel pump. To be connected to the ignition coil power supply. Connects in series with the original fuel line.Allows you to keep the manual pump. Avoids having to lift the hood to turn up gasoline before starting.Is intended to remain ...
(75,00 € HT)
Set of 8 pistons 66.04 Ford Vedette
Set of 8 pistons - New manufacture, similar to the original model - reduction in piston mass (approximately 255 gr with rings) - molybdenum treatment - cylinder dimension 66.04 mm. Supplied with segments, pins and circlips - The segments supplied ...
(1 290,00 € HT)
Ignition coil 12v VALEO
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(50,00 € HT)
Gearbox or axle oil SAE 80-140 - IGOL - 1L
Viscosity index 80 - 140API GL-4(Not suitable for Peugeot type screw axles)
(20,00 € HT)
Standard 6V coil ignition
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
(43,00 € HT)
Electronic regulator for 6V negative ground dynamo
Electronic regulator for 6V negative ground dynamo - Original appearance in ED3 housing.For dynamos with positive excitation.Charge stabilization at 7.4V. Brighter lighting, better battery charge quality, improved ignition voltage.(Exchange standard)
(208,00 € HT)

Ignition capacitor 6, 12 and 24V
6.12V and 24V compatible ignition capacitor.
(12,00 € HT)
Ford Vedette air filter + breather sticker
" Sticker for air filter and breather cap. Mounts on Ford V8 Vedette, Vendôme, Cometer, Monte Carlo etc. Sticker "
(19,26 € HT)
Ford Vedette Stromberg 22.2 Carburetor Kit
Overhaul kit for Stromberg 22.2 (2x30 mm) carburetor. Delivered with complete recovery pump. Fitting on Ford Vedette.
(80,00 € HT)
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
(8,50 € HT)
160 mm float fuel gauge - 6V
" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "
(40,00 € HT)
Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
(11,00 € HT)
Ford Vedette gear lever retaining or repair ring -
This part fits around the gearshift lever. Its purpose is to protect the bowl that receives the lever base from breakage. Over time, the metal (Zamac) weakens and breaks. This ring also serves to repair the bowl when it begins to break.
(56,00 € HT)
