Male thread brake reservoir
Brake fluid reservoir. Supplied with bracket, plug and 3/4 male connector 16 threads / p. External thread diameter = 18.5 mm. Delivered without caliper (fixing by the thread on the master cylinder). Lockeed and silicone compatible
(35,00 € HT)
Brake hose 445 mm front Dyna Z
Front brake hose Dyna Z Panhard - May 1958 at the end - length 445 mm
(27,00 € HT)
FRONT LEFT 28.5mm brake cylinder - Panhard PL 17 - Record mounting - 04/62 and fin
Front wheel cylinder L PL 17 - Record mounting - 04/62 and fine - d 28.57 mm. Left mounting.64 mm long - inside liquid passage = 10 mm
(55,00 € HT)

Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
7/16 banjo fitting + 7/16 hollow screw + seals
7/16 banjo fitting + 7/16 hollow screw + sealsDiameter male thread of the screw 11 mm
(27,35 € HT)
Canalisation Ø 6.35 mm bocal vers maitre cylindre - 0.5m - avec 2 raccords 1/2 mâle
Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...
(45,00 € HT)
Cylinder - front copper seal kit for one wheel - Panhard Dyna Z
Set of 2 seals for hollow screw and banjo (for 1 cylinder)Internal Ø 11 mm and 15 mm
(3,40 € HT)

Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)
Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
(3,89 € HT)