
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
(30,00 € HT)
Ignition protected harness Peugeot 203 - 403 petrol
Ignition harness for Peugeot 203/403 petrol engine.Current quality manufacture in red silicone.
(48,00 € HT)
Segment set Ø 75 mm Peugeot 203 403 - 7cv - 2x2x4.5
Segment set Ø 75 mm Peugeot 203 403 - 7cv - 2x2x4.5
(110,00 € HT)
Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
(11,00 € HT)
Valves x 4 - ADM Ø 37x8.5x116.4 - Peugeot 203 - 403
Set of 4 ADM valves Ø 37x8.5x116.4 - Peugeot 203 - 403
(116,67 € HT)
Valve guide x4 - +0.10 MM - 8.5x14.16x56.50 - Peugeot 203 - 403
Set of 4 cast iron intake and exhaust valve guides: outer bore repair dimension + 0.11 = Ø 14.16 - 8.5x14.11x56.50Peugeot 203 and 403, 1290cm³ TM4 TMP4 D4A engines, inner diameter 8.5mm, diam. ext. 14.05mm, length 55.4mm.(8 guides per cylinder head)
(24,92 € HT)
Ignition - complete igniter with vacuum - M48
Complete igniter with vacuum capsule AND centrifugal advance - similar curve Ducellier M48 - maximum advance 12 ° on igniter - delivered tested and greased. Dimensions :- length between shoulder (stop under the body) and end of trainer: 64mm- ...
(99,50 € HT)
Ignition finger igniter Ducellier 65mm
Finger for Ducellier distributor equipped with a 65mm headMounts with Ducellier 65 mm head
(11,25 € HT)
Battery switch - safety
Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.
(10,00 € HT)
Valves x 4 - ECH Ø 32.5x8.5x115.9 - Peugeot 203 - 403
Valves x 4 - ECH Ø 32.5x8.5x115.9 - Peugeot 203 - 403
(109,50 € HT)
Ignition head Ducellier 65 mm
Head for Ducellier distributor: Interlocking inside the head = 65 mm, outside about 72 mm.To be assembled with breakers 1 237 013 808, and ducellier finger.
(15,00 € HT)
Gasket paste for motor - auto extrudable cartridge 200 ml
Mot. Silicone gasket & self-extruding housing RTV K164 high-quality, heat-resistant silicone base: modified oxime silicone (acid-free hardening system)
(35,00 € HT)
Sandblasting tablet 52 mm pump side Peugeot 203 403
1 pellet diam. 52mm on cylinder head, behind water pump
(8,25 € HT)
Bearing set - Peugeot 203 - 403 STD side
Set of 3 bearings for Peugeot 203 and 403.Original standard dimension
(538,00 € HT)
Ignition coil 12v VALEO
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(48,00 € HT)
Valve guide x4 - + 0.05 MM - 8.5x14.11x56.50 - Peugeot 203 - 403
Set of 4 cast iron inlet and exhaust valve guides: outer bore repair dimension + 0.6 = Ø 14.11 - 8.5x14.11x56.50Peugeot 203 and 403, 1290cm³ TM4 TMP4 D4A engines, inner diameter 8.5mm, diam. ext. 14.05mm, length 55.4mm.(8 guides per cylinder head)
(24,92 € HT)