Set of 3 25mm pellets for cast iron cylinder head - Citroen Traction U23 HY
Set of 3 Ø25mm pellets only for cast iron cylinder head - Citroen Traction U23 HY
€11.00 TTC
(11,00 € HT)
(11,00 € HT)
Fuel gauge - replacement float
Float in synthetic material resistant to current fuels. Used to replace the cork floats on the fuel gauge Length: 1.40" Diameter: 1.14"
€17.72 TTC
(17,72 € HT)
(17,72 € HT)
Cast iron cylinder head exhaust gasket
Exhaust manifold gasket for cast iron cylinder head -Hy and Traction 11cv until 19632 seals are required per vehicle
€15.83 TTC
(15,83 € HT)
(15,83 € HT)
Fuel pump - 6V or 12V control push button
6 or 12v 10A push button. Can be used to activate an electric fuel pump for a few seconds, for example.
€8.25 TTC
(8,25 € HT)
(8,25 € HT)
Fuel pump - Horiz outlets - Citroen type Traction - U23 - HY
Fuel pump with primer, for Citroën Traction, delivered with gasket. Can also be mounted on U23 gasoline engine, HY, type H, and HZ equipped with the engine type Traction.
€30.00 TTC
(30,00 € HT)
(30,00 € HT)
Ignition - Citroen Traction U23 engine silicone harness
Ignition harness (5 wires) for Citroën Traction engine, U23. Highly recommended with electronic ignition.Wire with red silicone insulator, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
€58.29 TTC
(58,29 € HT)
(58,29 € HT)
Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
€11.00 TTC
(11,00 € HT)
(11,00 € HT)
Gearbox or axle oil SAE 80-140 - IGOL - 1L
Viscosity index 80 - 140API GL-4(Not suitable for Peugeot type screw axles)
€19.17 TTC
(19,17 € HT)
(19,17 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
€163.07 TTC
(163,07 € HT)
(163,07 € HT)
Support de manomètre
Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.
€7.94 TTC
(7,94 € HT)
(7,94 € HT)
New connecting rod for mounting with bearing - Citroen HY engine ID19
New connecting rod for assembly with bearing - Citroen Traction 11hp and 15hp and HY engine ID 19 current 63 and end of series.Supplied without pad. It is advisable to replace all 4 connecting rods at the same time.
€135.00 TTC
(135,00 € HT)
(135,00 € HT)
Engine red paint - 500 ml -
Engine red paint -Pot of 500 mlSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim ...
€33.00 TTC
(33,00 € HT)
(33,00 € HT)
paper gasket x 2 + thermal wedge for solex 32 pbic carburetor
kit 2 joints papier + cale thermique pour embase de carburateur Solex 32 pbi.
€12.46 TTC
(12,46 € HT)
(12,46 € HT)
Reinforced collar for exhaust - Ø 52-55 mm
Reinforced collar for exhaust - Ø 52.55 mmRobust French manufacturing
€5.42 TTC
(5,42 € HT)
(5,42 € HT)
