Exhaust - Y tube - 2 in 1 stainless steel - Ford Vedette
Stainless steel exhaust - Y connecting the 2 cast iron manifolds to line. Ford Vedette 1949 to 1954.
(363,67 € HT)

Exhaust - stainless steel oval silencer - Ford Vedette
Stainless steel silencer for Ford Vedette.
(379,00 € HT)

copy of Exhaust - outlet tube + stainless steel stock - Ford Vendome - MONTE CARLO
" Outlet tube with bracket (passage of the bridge) to be connected to the outlet of the silencer. Ford Vendôme and Monte Carlo. All stainless steel. "
(24,95 € HT)

16 other products in the same category:
Echappement joint extremite bloc V8 Ford Vedette et Simca
" Exhaust gasket, engine block outlet, small model placed at the ends. 4 on one engine - Sold individually. "
(6,00 € HT)
Ford Vedette air filter + breather sticker
" Sticker for air filter and breather cap. Mounts on Ford V8 Vedette, Vendôme, Cometer, Monte Carlo etc. Sticker "
(19,26 € HT)
Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
(11,00 € HT)
Regulateur électronique pour dynamo 6V positif à la masse - Ford Vedette - Simca Versailles
(208,00 € HT)

Ignition capacitor 6, 12 and 24V
6.12V and 24V compatible ignition capacitor.
(12,00 € HT)
Support de manomètre
Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.
(7,94 € HT)
Aerosol gasket for cylinder head
Sealing spray varnish to be sprayed on both sides of a cylinder head gasket. Improves sealing, essential with solid copper gaskets (any thickness)
(35,00 € HT)
Standard 6V coil ignition
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
(43,00 € HT)
Ignition coil 12v VALEO
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(50,00 € HT)
Kit of 12V electric fuel pump
" 12V electric fuel pump. Connects in series with the original fuel line. Keeps the hand pump. Avoids having to lift the hood to turn up gasoline before starting. To be powered through a push button for occasional operation. Low pressure, no need ...
(80,00 € HT)
160 mm float fuel gauge - 6V
" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "
(40,00 € HT)
6V electric fuel pump
6V electric fuel pump. To be connected to the ignition coil power supply. Connects in series with the original fuel line.Allows you to keep the manual pump. Avoids having to lift the hood to turn up gasoline before starting.Is intended to remain ...
(75,00 € HT)
Crankshaft bearing screws Ford 49 to 52
Set of bearing screws for V8 Ford Vedette model 1949 to 1952
(134,42 € HT)
Aviation collex type paste gasket for cylinder head - 117ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(25,00 € HT)