Ecrou
(4,80 € HT)
Brake reservoir with rubber
Translucent tank, delivered with bracket; rubber plug and fitting.
(32,00 € HT)
Rear brake cylinder 25.4 mm - Peugeot 403
Rear wheel cylinder repair kit, with pistons and spring. (For one wheel)Piston diameter = 25.4 mm
(21,85 € HT)

Brake line - from 150 to 200 cm
Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.
(57,70 € HT)
Brake reservoir - male thread + electrical contact
Brake fluid reservoir, translucent plastic. With cap, and electrical contact for low fluid level
(39,50 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)
Brake switch - stop - DOT 3 and 4
" Brake switch. STOP light function - compatible with synthetic liquid type" "lockheed" "Dot 3 and 4. If using 100% silicone liquid: Choose this other reference 1/2 - 20 thread / inch thread "
(16,29 € HT)
Brake pipe - from 250 to 300 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(69,70 € HT)
1/2 female 20 UNF connection on 8 mm tube (metal brake jar)
Metal tank foot nut (female 1/2 and d 8mm)
(9,25 € HT)
Brake line - from 0 to 50 cm
Brake line remanufactured on demand only in copper diameter 6.35 mm. Small model, length less than 50 cm. Provide model (length and 2 original tips) Shipping after receipt of your model.
(39,70 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Lower front brake cylinder L or R 28.5 -Peugeot 403
Single piston cylinder without bleeder for front wheel - Peugeot 403 all models - Lower left or right mounting - French manufacture - (2 upper cylinders and 2 lower cylinders are needed to equip the front of a 403) - NON CONTRACTUAL photo.
(53,00 € HT)
