Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
(8,50 € HT)
Fuel pump with lever Peugeot 203/403
Fuel pump with Peugeot 203, 403, utility D3, D4 and derivatives. Supplied with base gasket.
(35,00 € HT)
Bearing set - Peugeot 203 - 403 STD side
Set of 3 bearings for Peugeot 203 and 403.Original standard dimension
(538,00 € HT)
Exhaust support strap reinforces 90 mm
Suspension strap for exhaust. Robust construction, reinforced rubber, metal eyelets.92 mm center distance for M8 mm screws.
(13,48 € HT)
80 mm FLAT piston liners set - Peugeot 403 - D4 - 8cv
Set of 4 liners + 4 complete FLAT pistons (segments, clips, axles) for Peugeot 403 (8cv). The manufacture of the pistons and the choice of segmentation are guaranteed of quality.New product. Original STD dimension, bore 80 mm.
(290,00 € HT)
Ignition set of Ducellier breakers
Set of breakers for Ducellier distributor For Renault Prairie, R2087, Goélette and derivatives
(12,00 € HT)
Valve guide x4 - original - 8.5x14.05x56.50 - Peugeot 203 - 403
Set of 4 valve guides adm. and cast iron scale: original outside bore Ø 14.05 - 8.5x14.05x56.50Peugeot 203 and 403, 1290cm³ TM4 TMP4 D4A engines, diam. int. 8.5mm, diam. ext. 14.05mm, length 55.4mm.(8 guides per cylinder head)
(24,92 € HT)
Ignition coil 12v VALEO
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(50,00 € HT)
gasket for solex 32 pbic carburetor
2 x paper gaskets for Solex 32 pbi carburetor base.Fixing center distance: 60 mmCentral passage: 32 mmTotal length: 78 mmwidth: 50mm
(3,80 € HT)
Fuel needle - Solex 32 PBIC carburettor or similar
Fuel needle - Solex 32 PBIC carburettor or similar
(9,90 € HT)
Ignition - protected harness Peugeot D3 D4 petrol
Ignition harness for Peugeot D3 D4 petrol engine.Current quality manufacture in red silicone.
(48,00 € HT)
Ignition head Ducellier 65 mm
Head for Ducellier distributor: Interlocking inside the head = 65 mm, outside about 72 mm.To be assembled with breakers 1 237 013 808, and ducellier finger.
(15,00 € HT)
Battery switch - safety
Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.
(10,00 € HT)