
Shaft 8.5 mm Ø repair - repair Solex 32 PBIC carburettor or similar
Shaft dimension repair 8.5 mm with butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm
(22,00 € HT)
Speedometer cable - Peugeot 203 - all models
Speedometer cable for Peugeot 203 convertible, sedan, commercial pick-up, all models (Non-contractual photo)
(45,00 € HT)
2-wire fuel gauge - Peugeot 203
2-wire fuel gauge - Peugeot 203. Meticulous manufacturing
(37,50 € HT)
Engine seal kit Peugeot 203 D3 7cv engine
Seal kit Peugeot 203 and D3 with 7cv engine bore 75 mm. Included cylinder head gasket, liner base gasket, manifold, etc.
(51,53 € HT)
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
(30,00 € HT)
Bearing clutch Peugeot 203 - 403 - D3 - D4
Graphite stop for clutch mechanism.
(60,00 € HT)
Ignition protected harness Peugeot 203 - 403 petrol
Ignition harness for Peugeot 203/403 petrol engine.Current quality manufacture in red silicone.
(48,00 € HT)
IGOL 20W50 mineral oil - 5L can
5 l can (non contractual photo) - Viscosity: 20W-50BenefitsHéRITAGE GTZ mineral oil.Multigrade lubricant for Gasoline and Diesel engines, made from severely refined mineral bases and additives suitable for older engines. The anti-wear additive ...
(30,00 € HT)
Brushes or carbon for Peugeot 203 403 disengageable water pump
Contact with brushes (carbon) for Peugeot 203 403 disengageable water pump. Delivered with the wire.
(31,00 € HT)
Ignition capacitor 6, 12 and 24V
6.12V and 24V compatible ignition capacitor.
(12,00 € HT)
Connecting rod bearings set - Peugeot 203 - 403 dimension 0.30
Set of bearings for 4 Peugeot 203 and 403 connecting rods.Repair dimension 0.30. French made.
(150,00 € HT)
Segment set Ø 75 mm Peugeot 203 403 - 7cv - 2.5x2.5x4.5
Segment set Ø 75 mm Peugeot 203 403 - 7cv - 2.5x2.5x4.5
(110,00 € HT)
Reinforced collar for exhaust - Ø 64-67 mm
Reinforced collar for exhaust - Ø 64-67 mmRobust French manufacturing
(6,50 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
(163,07 € HT)
Valves x 4 - ADM Ø 35x8.5x121.7 45 ° - Peugeot 203
Set of 4 ADM valves Ø 35x8.5x121.7 angle 45 ° - Peugeot 203
(96,00 € HT)
Connecting rod bearings set - Peugeot 203 - 403 dimension 0.50
Set of bearings for 4 Peugeot 203 and 403 connecting rods.Repair dimension 0.50. French made.
(245,00 € HT)