- New

You need to adjust gap before to place in each cylinder Set of 12 rings - fit to LR2, LR4, LR4N2 engine Ø 56.50 (somme are 57 mm) - 8 x compression hauteur 2mm - 4 x racleur hauteur 3 mm Attention certains segments sont livrés en Ø 57 mm . Vous devrez ajuster le jeu à la coupe AVANT montage...
You need to adjust gap before to place in each cylinder
Set of 12 rings - fit to LR2, LR4, LR4N2 engine Ø 56.50 (somme are 57 mm)
- 8 x compression hauteur 2mm
- 4 x racleur hauteur 3 mm
Attention certains segments sont livrés en Ø 57 mm . Vous devrez ajuster le jeu à la coupe AVANT montage dans les cylindres
Nous contacter pour d'autres dimensions.
Roller bearing, rear crankshaft bearing assembly (flywheel side) for LR2, LR4, LR4N2 engines and derivatives.
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
Mano "OS" Tachometer 0 to 5000 rpm for 4-cylinder petrol engine. Connects to the "break" terminal on the ignition coil. 52 mm recess on the pressure gauge side. delivered with lighting. for negative to ground
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
"Plastigage"The Calibrouge ("plastigage or plastigauge") is a simple and practical tool for measuring the clearances of your bearings. Range of use: operating clearance from 0.025 to 0.175 mm
Set of 16 segments (4 per piston) for LR2, LR4, LR4N2 engines and derivatives. Bore 58. Attention in case of error on your part, these products cannot be taken back.- 8 x compression h 2mm- 8 x scraper h 3 mmContact us for other sizes.
Engine red paint -Pot of 500 mlSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim ...
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.
Suspension strap for exhaust. Robust construction, reinforced rubber, metal eyelets.92 mm center distance for M8 mm screws.
Dark green engine paint RAL 6005 -Pot of 500 mlSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated ...
Bearing for Rosengart dynamo size 17x39x9 type 99203Non contractual photo
Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
Black paint - 500 ml jarSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim 4090), ...