Set of 8 pistons - New manufacture, similar to the original model - reduction in piston mass (approximately 255 gr with rings) - molybdenum treatment - cylinder dimension 66.04 mm. Supplied with segments, pins and circlips - The segments supplied ...
(867,00 € HT)
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(33,00 € HT)
Stainless steel exhaust - Y connecting the 2 cast iron manifolds to line. Ford Vedette 1949 to 1954.
(329,55 € HT)
Sleeve Ø 66.04 mm delivered semi finished in Ø 65.80 - long 145 mm - Ø 69 - collar Ø 70 - High collar 5 mm - Ford Vedette - sold individually
(39,58 € HT)
Hose to connect the igniter / carburetor depression 6 mm sold by the meter.
(8,50 € HT)
Paper fuel filter for 6 or 8 mm hose.
(6,00 € HT)
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
(33,00 € HT)
Exhaust gasket, engine block outlet (center). 2 per engine - Sold individually.
(6,00 € HT)
Solid copper cylinder head gasket. 2mm thickness. Used with planed cylinder head. Tightening to 5m.kg. Mandatory installation with aerosol sealant, available here a>. Measured cylinder head thickness Head gasket type 37.3 mm ...
(110,50 € HT)
Gasket to be placed between the central crankcase and the base of the oil filter. "Y" shaped.
(15,00 € HT)
Secondary propeller-dynamo belt for Ford Vedette
(22,00 € HT)
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(35,00 € HT)
Stainless steel silencer for Ford Vedette.
(342,22 € HT)
"Plastigage"The Calibrouge ("plastigage or plastigauge") is a simple and practical tool for measuring the clearances of your bearings. Range of use: operating clearance from 0.025 to 0.175 mm
(16,00 € HT)
Bosch High Voltage coil for ignition with platinum or electronic screws, voltage 12 V. Supplied with bracket.
(60,00 € HT)
Metal support, black lacquered for standard manometer D52 mm. Ready to fix.
(10,00 € HT)