
Valves x 4 - ADM Ø 37x8.5x116.4 - Peugeot 203 - 403
Set of 4 ADM valves Ø 37x8.5x116.4 - Peugeot 203 - 403
(116,67 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
(163,07 € HT)
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
(8,50 € HT)
Complete set of solex 32 pbic carburetor gaskets
Solex 32 pbic carburetor gaskets kit - accelerator pump diaphragm included (Colorale, Goélette, R2087, Frigate, etc) Version with manual starter
(34,13 € HT)
Engine paint black RAL 9005 - 500 ml
Black paint - 500 ml jarSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim 4090), ...
(34,00 € HT)

Bearing 6203 - 17x40x12
Bearing - 17x40x12 waterproof (often used on dynamo, water pump, flywheel center, etc.). Check with the dimensions of your bearing.
(9,00 € HT)
Engine red paint - 500 ml -
Engine red paint -Pot of 500 mlSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim ...
(34,00 € HT)

Ignition finger igniter Ducellier 65mm
Finger for Ducellier distributor equipped with a 65mm headMounts with Ducellier 65 mm head
(11,25 € HT)
Connecting rod bearings set - Peugeot 203 - 403 standard dimension
Set of bearings for 4 Peugeot 203 and 403 connecting rods. Standard original dimension. French manufacture.
(135,00 € HT)
Fuel gauge - replacement plastic float
White plastic float. Used to replace ring gauge floats.
(12,50 € HT)
Peugeot 203 air filter
Paper cartridge for Peugeot 203 air filter. Conforms to original dimensions.Diam 140/150 mm - height 60/65 mm - central hole 90 mm approximately
(22,00 € HT)
Valves x 4 - ADM Ø 35x8.5x116.4 - Peugeot 203
Valves x 4 - ADM Ø 35x8.5x116.4 - Peugeot 203
(110,00 € HT)
Reinforced collar for exhaust - Ø 44-47 mm
Reinforced collar for exhaust - Ø 44-47 mmRobust French manufacturing
(4,83 € HT)
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
(30,00 € HT)
Axle 8.5 mm Ø repair - without butterfly - Solex 32 PBIC or similarsimilar
Shaft dimension repair 8.5 mm without butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm
(14,13 € HT)